Allen

TECH 458 Quality Assurance

Department of Engineering and Design

Eastern Washington University

Spring Quarter 2013

Assignment 3 & Help Sheet (30 Points)

Assignment:

You will complete the following numbered exercise problems shown in Chapter 10, starting on page 438, from our textbook “Statistical Process Control and quality Improvement”: 2, 4, 6, 8, 10, 12, & 14. Use MS Word or its equivalent. List each problems number followed by a description of what type of problem is present in the control chart. Then, list three possible causes for each out-of-control chart.

Formatting:

Text Size: All of the text in this assignment needs to be set in 12-point size. Please resist the temptation to mix and match point sizes. If you doubt your applications intentions, just select all of your text and insure that it is in 12-point size.

Margins: One-inch margins mean one (1”) on all sides. The only text that ends up on the outside of the one-inch margin is the page number.

Double Spacing: For this class select all of your text and set it for double spacing. This includes the name block, title and body of your work. This allows space for marking up or making notes while I am reviewing what you have written.

Name Block: Place the name block in the
upper right
corner of the page. In this class, the name block only needs to be on the first page. Put your
name first
, then the
class title
and then the
date
. Example:

Your Name

TECH 458 Quality Assurance

May 29, 2013

Title: Please place the title just below the name block. The title
for this
assignment is “Assignment 3”.

Saving/Naming Your File:

When you save your file make sure that your name and the project number are included in it.

Example:
YourName458Asgnmt3

Because of problems with Blackboard, use only letters and numbers in the file name.

Due Date: May 29, 2013

Revised 4/27/2012 TG
Page 1