CT 312 Grantham University Week 6 Memory and Basic I O Interfaces Lab Report

Advanced Microprocessors and Lab – Week 6 Lab 1

Memory and Basic I/O Interfaces

Work problem 27, pg. 376.

Work problem 35, pg. 449.

Include the source code in a Word document entitled “Lab6_StudentID,” where your student id is substituted in the file name.

Upload file “Lab6_StudentID”.

Lab Template

– This lab template should be used for your lab reports.

10

Grading Criteria	Points
All problems or questions attempted	30
Final solutions clearly indicated		10
Correct numerical solution	50
Correct units
Total

Name:
GID:
Lab 1:
Grantham University
Date:
Note: When writing the report, make sure you write in 3rd person
Introduction:
Write one to two paragraphs about the Lab. Explain the following information for this lab:
▪
▪
▪
▪
What are the goals to achieve in the lab?
What are the expectations of the lab?
How will you be implementing this lab?
What will you try to measure?
Equipment/Components:
List the type of equipment or components that you will be using? Where will you find these
components? How will you use these components in Multisim/VHDL? Explain any adjustments required
such as tolerances.
Procedure:
Briefly describe how you will approach the problem and try to solve the lab, describe and explain any
techniques/rules/laws/principles you would use. Outline each step of the process.
Calculations:
Include circuit analysis and all calculations here (if applicable).
Circuit design:
Take a screenshot of the circuit/logic from Multisim/VHDL as asked in the lab assignment before you run
the circuit and paste it here in your report.
Execution/Results:
Run the circuit in Multisim/VHDL and copy/paste the results from the simulation including any readings,
plots or graphs.
Copy/Paste the screenshots for all the measurements required in the lab here. Be sure to add a title and
explain what each of the screenshots represent.
Analysis:
Analyze the results obtained from Multisim/VHDL and compare those to your calculated results (if
applicable).
Answer the following questions:
▪
▪
▪
▪
What did you discover/confirm?
Use tables and diagrams to record results.
Compare calculations with the measured values.
Analyze your results.
Explain if your simulation is correct or incorrect and why. If the results are confirmed, then your
measurements are correct. If they are not confirmed, explain what the problem is. You will need to
discuss how to troubleshoot the circuit to achieve the correct results.
Conclusion:
Summarize the entire lab in 1 to 2 paragraphs with the results and analysis in mind.
Answer any questions asked in the lab assignment here.
Cite any sources that you may use in your report.
27. Modify the circuit of Figure 10–19 by rewriting the PLD program to address memory at
locations A0000H-BFFFFH for the ROM.
35. Develop a time delay procedure for the 2.0 GHz Pentium 4 that waits for 80 us.